Saturday, August 10, 2019

Terminating Fiber Optic Cable Using a Polish Method ,Testing Wired Essay

Terminating Fiber Optic Cable Using a Polish Method ,Testing Wired Media Both Copper and Fiber - Essay Example Company). For the termination of fiber optic, we first start the preparation for fiber termination that generally contains the procedure for gathering the supplies that we will furthermore require, cutting the Kevlar, stripping the outer jacket and buffer or coating. For supplies, we will definitely require safety glasses, connectors, a fiber disposal bin, epoxy and syringes, fiber optic cable and a polishing film.In addition, tools that are used in fiber optic termination consist of fiber notch, stripper, adjustable cable jacket stripper, Aramid fiber scissors, polishing glass plate, polishing puck plus a rubber pad to polish the PC connectors whose sole purpose is the single mode termination (CableOrganizer.com, Inc. Company). During this process we will prepare the fiber optics for termination. First we remove the cladding and the cover and then pursue the following steps: Fill the syringe by ready to use paste. Strip back the outer shield of the cable by using a rotary stripping tool. Restrain the Aramid safety component with ceramic or Kevlar scissors. Slide the twist relief boot onto the fiber to be terminated. Afterward Strip the main buffer of the fiber by using fiber strippers and be careful not to use ordinary wire strippers. Here we need to apply this on a small section at a time to avoid the fiber optic fracture, approximately 10mm (3/8 inches) on each cut will be fine until or unless we get used to it. Strip back about 30mm (1.25 inches). Then we will fix the connector. Then we need to inject the paste into the connector’s body for an expectation of a small drop that might comes out at the end of the ferrule. Clean the uncovered fiber by using fuzz free wipe as well as isopropyl alcohol, you would see that it will "squeak" when it is clean. Afterward we will apply the primer to the bare fiber either by using the brush supplied or by dropping it into the bottle. After that we will push the fiber into the

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.